Utilizing Bat1 only
The battery configuration below only allows for a maximum of 50Amps discharge from the battery, the below settings are used for this type of battery setup. The discharge current can only be set to 50Amps only.
Utilizing both battery ports and 1 BMS on the inverter
The battery configuration below allows for the full 100Amp discharge. The Parallel Bat1&2 must be enabled for this type of configuration.
Utilizing each port with its own battery
This type of battery configuration allows for a full 100Amp discharge from the batteries connected, both battery BMS's are connected to the inverters and can be viewed on the LiBms pages 1&2 on the inverter.
The Parallel Bat1&Bat2 must not be enabled in the settings as shown below as each input is independently connected as shown in the image below.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article